Step 14
B27
1 Install a left roof panel at the left rear and right front corner of the roof. Install a right roof panel at the left front corner of the roof.
2 Cut 2 short 2" (5cm) strips off the
roll of weather stripping tape, and put them aside. Cover the joint at the peak with weather stripping tape. Unroll the tape and press it down over the opening at the ridge as you install each roof panel. Do not cut the tape at this time.
3 Install 4 roof panels in the se-
● Parts Needed For ●
RoofAssembly
STEP | 8467 Left Roof Panel |
|
1
8466 Right Roof Panel
FRONT
●8467 Left Roof Panel (2)
●7875 Roof Panel (4)
●8466 Right Roof Panel (1)
STEP
Weather Stripping2 Tape Roll
7875 Roof Panel
quence and positions shown on pre- vious page. Do not fasten the lower end of the panels to the side wall angles at this time. Continue weather stripping the ridge opening. Fasten roof panel overlaps not used for ridge cap (roof center). Cover the head of bolt with the 2" (5cm) piece of weather stripping tape.
Screws To
Roof Beam
|
| STEP |
|
|
|
Fasten At | Fasten At | 3 |
Overlap with | Overlap with |
|
| ||
Bolt | Bolt |
|
Screws To |
|
|
Roof Beam |
|
|
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
NOTE
If roof beam holes do not line up with the roof panel holes, shift the building from left to right.
If this does not help, your building
may not be level. Shim the corners until holes line up.
Do not fasten |
|
at this time | Strips |
Cut |
| |
Weather Stripping | FRONT | |
and Fold Under | ||
|
27