Step 13
B26
Installing the roof panels is best done with a step ladder. Begin installing roof panels at the back right corner of the building. Each screw and bolt in the roof requires a washer.
NOTE
Measure the building diagonally again and make adjustments to make sure the building is square and level. This will make the roof panels fit better, and holes will align. Don't anchor the floor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels by their
numbers. Note the sequence and position they are to be installed.
2 Position the right roof panel at the
back right corner and fasten to the gable with 5 bolts and nuts and roof beams using 2 screws. Do not fasten the lower end of the panel to the side wall angle at this time.
Hint: Attach fasteners in order shown in diagram.
● Parts Needed For ●
Right Roof Panel |
| ● 8466 Right Roof Panel (1) | ||
|
|
| ||
|
|
|
|
|
|
| STEP |
|
|
|
|
|
|
|
|
| 1 |
|
|
|
|
|
|
|
8467 | 2 | 1 | 8466 | |
7875 | 6 | 5 | 7875 | |
7875 | 8 | 7 | 7875 |
8466 | 4 | 3 | 8467 |
FRONT
STEP
2
6 8466 Right Roof Panel
1 | 7 |
|
|
| |
| 2 | 3 |
|
| |
|
| 4 |
5
Nut
Washer
Gable | Bolt |
|
26