Arrow Plastic EH86S, WL86-A, VL8662-A, LM86, EH86-A Gables/Braces, Join the left and right gables

Page 24

1 Lift and fasten a right and left

gable, under angle at corner, to the rear wall angle with screws.

Hint: On the rear gable, use a bolt and nut at the overlapping rear wall angle. On the front gable, leave out 2 screws closest to center gable leg.

2 Join the left and right gables

together with a gable brace using bolts and nuts in the bottom two holes only.

3 Repeat Steps 1 & 2 for the door

track on the front of building, except for the track supports, fasten as shown.

STEP

1 Gable

6658 Gable Brace

STEP

Track Supports 6228

STEP

Image 24

Contents EH86S Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Roof Strengthening heavy snow load KitsThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation Foundation For Your Building97 1/2 47m Anchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Step Floor Frame AssembliesPlace the front floor frames as Overlap the rear floor frames asFrame Assemblies Overlap the rear wall channelRoof Beam Assembly Place the side wall angle, backDoor Track Assembly Using the door track spliceFloor Frame Corners Position the rear corner panels atPosition a front corner panel at Fasten the door track assembly FramesFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Gables/Braces Join the left and right gablesRoof Beams Right Roof Panel If a Roof Beef-Up Kit wasRoofAssembly FrontRidge Cap Roof Trim Door Assembly Hold the vertical door bracePut a horizontal door brace onto Attach the lower door guidesDoor Installation & Adjustment Repeat steps 1 through 3 for Left doorEH86-A LM86 ML86-A SA8662-A VL8662-AWL86-A