Arrow Plastic EH86-A, WL86-A, VL8662-A, LM86, EH86S, SA8662-A, ML86-A owner manual Roof Beams

Page 25

Step 12	● Parts Needed For ●
Step 12	Roof Beams
B25

●Main Roof Beam (1)

●8474 Roof Beam (2)

1 Fasten the main roof beam to the

gable brace of the front gable.

2 Fasten the other end of the main

roof beam to the gable brace of the rear gable.

3 Fasten the remaining roof beams, small holes on top, as shown using bolts and nuts.

STEP

3

8474 Roof Beam

STEP

2

STEP

1

Main Roof Beam Assembly

25

Image 25

Contents EH86S Before YOU Begin Required Eye Goggles No Phillips Screwdriver Plan AheadSafety First Other Tips Care & MaintenanceRoof Strengthening heavy snow load Kits AccessoriesThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation For Your Building Foundation97 1/2 47m Anchoring Down The Building AnchoringHardware Parts List Assembly by Key No Floor Frame Assemblies StepPlace the front floor frames as Overlap the rear floor frames asOverlap the rear wall channel Frame AssembliesPlace the side wall angle, back Roof Beam AssemblyUsing the door track splice Door Track AssemblyFloor Frame Position the rear corner panels at CornersPosition a front corner panel at Frames Fasten the door track assemblyFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Join the left and right gables Gables/BracesRoof Beams If a Roof Beef-Up Kit was Right Roof PanelFront RoofAssemblyRidge Cap Roof Trim Hold the vertical door brace Door AssemblyPut a horizontal door brace onto Attach the lower door guidesRepeat steps 1 through 3 for Left door Door Installation & AdjustmentLM86 ML86-A SA8662-A VL8662-A EH86-AWL86-A