Arrow Plastic WL86-A, VL8662-A, LM86, EH86S, EH86-A, SA8662-A, ML86-A owner manual Wall Panels

Page 21

Step 8	● Parts Needed For ●
Step 8	Wall Panels
P21

●6515 Wall Panel (4)

●6243 Wall Panel (2)

The wall panels come in two widths. Each wall panel has a crimped rib on one side. The crimped rib should go under the rib of the panel that follows it.

1 Locate all of the wall panels and set each one alongside the building.

2 Be sure that you have the correct

panels in each position. Do this by overlapping the panels and deter- mining if the holes line up with the holes in the frame.

3 Fasten the wall panels at the top

and bottom with screws.

4 Fasten the center of each panel to

the wall channel with screws. Fasten overlapping ribs using a bolt and nut with two screws.

STEP

1			6243	6243
			6243	6243

6515
6515
6515					STEP
					STEP

					2

				6515
			Panels rest on	6515
			Panels rest on
			frame as shown

			Crimped Rib
			Underneath
				Detail Showing
				Center of Panel
				Screwed to
				Wall Channel

5 When you have attached all wall panels in the correct positions, the building will look like this.

STEP

3

Use bolts and nuts thru wall angle overlap at the top of panel at rear.

STEP

5

STEP

4

Bolt and nut does not go thru wall channel

at overlap

21

Image 21

Contents EH86S Before YOU Begin Required Eye Goggles No Phillips Screwdriver Plan AheadSafety First Other Tips Care & MaintenanceRoof Strengthening heavy snow load Kits AccessoriesThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation Foundation For Your Building97 1/2 47m Anchoring Down The Building AnchoringHardware Parts List Assembly by Key No Floor Frame Assemblies StepPlace the front floor frames as Overlap the rear floor frames asOverlap the rear wall channel Frame AssembliesPlace the side wall angle, back Roof Beam AssemblyUsing the door track splice Door Track AssemblyFloor Frame Corners Position the rear corner panels atPosition a front corner panel at Frames Fasten the door track assemblyFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Join the left and right gables Gables/BracesRoof Beams If a Roof Beef-Up Kit was Right Roof PanelFront RoofAssemblyRidge Cap Roof Trim Hold the vertical door brace Door AssemblyPut a horizontal door brace onto Attach the lower door guidesRepeat steps 1 through 3 for Left door Door Installation & AdjustmentEH86-A LM86 ML86-A SA8662-A VL8662-AWL86-A