Arrow Plastic LM86, WL86-A, VL8662-A, EH86S Roof Beam Assembly, Place the side wall angle, back

Page 16

Step 3	● Parts Needed For ●
Step 3	Roof Beam Assembly
B16

●8474 Roof Beam (1)

●8476 Side Wall Angle (1)

The roof beams join the two gables and support the roof panels. The main roof beam is made up of two pieces fastened together.

1 Place the side wall angle, back-

to-back, with a roof beam and fasten together using ten screws.

2 Set this piece aside for later use.

Assembled

8476 Side Wall Angle

STEP

1

8474 Roof Beam

Main Roof Beam

16

Image 16

Contents EH86S Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Roof Strengthening heavy snow load KitsThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation For Your Building Foundation97 1/2 47m Anchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Step Floor Frame AssembliesPlace the front floor frames as Overlap the rear floor frames asFrame Assemblies Overlap the rear wall channelRoof Beam Assembly Place the side wall angle, backDoor Track Assembly Using the door track spliceFloor Frame Position the rear corner panels at CornersPosition a front corner panel at Fasten the door track assembly FramesFasten the rear wall angle as Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Gables/Braces Join the left and right gablesRoof Beams Right Roof Panel If a Roof Beef-Up Kit wasRoofAssembly FrontRidge Cap Roof Trim Door Assembly Hold the vertical door bracePut a horizontal door brace onto Attach the lower door guidesDoor Installation & Adjustment Repeat steps 1 through 3 for Left doorLM86 ML86-A SA8662-A VL8662-A EH86-AWL86-A