Arrow Plastic EH86S, LM86 Door Installation & Adjustment, Repeat steps 1 through 3 for Left door

Page 31

Step 18

● Parts Needed For ●

Door Installation & Adjustment

P31

 

●Right Door Assembly (1)

●Left Door Assembly (1)

1 From inside the building, put the bottom of the right door assembly (on your left when you are inside the building) behind door jamb into the front frame track.

2 Position the top of the door so that

the holes in the door line up with the holes in the door slides.

3 Fasten the door to the door slides

using two #10Bx1/2" screws per door slide.

Horizontal Door Brace

Gable

Door Track

Door Slide

Door

 

STEP

 

 

1

 

 

Front Floor Frame Assembly

STEP

2

Door Slide

NOTE

 

 

The holes in the door slides allow

 

 

you to adjust the doors. Place the

 

 

door in the middle holes.

 

Adjustment Holes

 

 

 

4 Repeat steps 1 through 3 for the

 

left door.

 

Adjustment Holes Allow

Doors to Meet Evenly

Along Their Length

#10Bx1/2" Screw

STEP

3

RightLeft

DoorDoor

STEP

4

Keep this Owner's Manual and Assembly Instructions for future reference. 31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents EH86S Before YOU Begin Required Eye Goggles No Phillips Screwdriver Plan AheadSafety First Other Tips Care & MaintenanceRoof Strengthening heavy snow load Kits AccessoriesThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation For Your Building Foundation97 1/2 47m Anchoring Down The Building AnchoringHardware Parts List Assembly by Key No Overlap the rear floor frames as StepFloor Frame Assemblies Place the front floor frames asOverlap the rear wall channel Frame AssembliesPlace the side wall angle, back Roof Beam AssemblyUsing the door track splice Door Track AssemblyFloor Frame Position the rear corner panels at CornersPosition a front corner panel at Fasten the rear wall channel as Fasten the door track assemblyFrames Fasten the rear wall angle asWall Panels Door Jamb Gable Assemblies Join the left and right gables Gables/BracesRoof Beams If a Roof Beef-Up Kit was Right Roof PanelFront RoofAssemblyRidge Cap Roof Trim Attach the lower door guides Door AssemblyHold the vertical door brace Put a horizontal door brace ontoRepeat steps 1 through 3 for Left door Door Installation & AdjustmentLM86 ML86-A SA8662-A VL8662-A EH86-AWL86-A
Top Page Image Contents