Arrow Plastic VL8662-A, WL86-A, LM86, EH86S, EH86-A, SA8662-A, ML86-A owner manual Door Jamb

Page 22

Step 9	● Parts Needed For ●
Step 9	Door Jamb
P22

●9369 Door Jamb (2)

The door jambs reinforce the door opening and provide an attractive trim. Follow these steps for both door jambs.

1 Fasten a door jamb to the front panel with three bolts, nuts and acorn nuts, as shown. Push a plug into hole at center of jamb, closest to door opening.

2 Fasten the top of the door jamb to

the door track with two screws. Do the same for the bottom into frame.

Repeat steps 1 through 2 for the opposite door jamb.

INSIDE OF

BUILDING

TOP VIEW

(3) bolts

Door Track

Acorn Nut

	9369
	Bolt
		Cross-Section
Plug	TOP VIEW	Top View
Hex Nut	Door Track
9369		Plug
9369

		STEP

TOP VIEW

Door Track

ScrewScrew

STEP

Image 22

Contents EH86S Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Roof Strengthening heavy snow load KitsThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation For Your Building Foundation97 1/2 47m Anchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Place the front floor frames as StepFloor Frame Assemblies Overlap the rear floor frames asFrame Assemblies Overlap the rear wall channelRoof Beam Assembly Place the side wall angle, backDoor Track Assembly Using the door track spliceFloor Frame Position the rear corner panels at CornersPosition a front corner panel at Fasten the rear wall angle as Fasten the door track assemblyFrames Fasten the rear wall channel asWall Panels Door Jamb Gable Assemblies Gables/Braces Join the left and right gablesRoof Beams Right Roof Panel If a Roof Beef-Up Kit wasRoofAssembly FrontRidge Cap Roof Trim Put a horizontal door brace onto Door AssemblyHold the vertical door brace Attach the lower door guidesDoor Installation & Adjustment Repeat steps 1 through 3 for Left doorLM86 ML86-A SA8662-A VL8662-A EH86-AWL86-A

Step 9

Door Jamb