Husqvarna Rider 155 manual Lever for adjustment of cutting height, Seat, Fuelling

Page 19

PRESENTATION

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to 9 different positions.

Combi 103 unit,	45-95 mm
	(1 3/4" - 3 3/4")

Seat

The seat has a jointed attachment on the front edge and can be tipped forward.

The seat can also be adjusted lengthways.

Release the knobs under the seat and adjust it forwards or backwards to the required position.

Lock the setting with the knobs.

Fuelling

The engine should be run on 87 octane (or higher) unleaded petrol/gasoline (no added oil).

Gasohol or MTBE mix, see “Technical Data”.

No other fuel is approved by Kohler Engines.

Do not fill the tank completely, leave an expansion area of at least 2.5 cm (1").

WARNING! Petrol/gasoline is highly inflammable. Observe care and fill up with fuel outdoors (see safety instructions).

6004-013H

6004-014H

6004-015

English – 17

Image 19

Contents English RiderSvenska Contents III. Children Safe operation practices for ride-on mowersGeneral operation II. Slope operationIntended use IV. ServiceTravel and transport on public roads TowingTowing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceStarting Instruction Explanation of SymbolsPlacards General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Cold engine DrivingBefore starting Starting the engineWarm engine Driving the machine Cutting tips Release lever Stopping the engineHours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removal of the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Adjusting the throttle wireService of the air filter Ignition system BatteryFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit 6017-216 Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belt Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pinDip stick must not be screwed down LubricationCheck the engine’s oil level Changing the oilGeneral lubrication Lubricating the belt adjusterChange of oil filter Check the transmission’s oil levelProblem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data Work done Date, mileage, stamp, sign Service JournalService Journal ´+H-¶5c¨ English 114 01