Husqvarna Rider 155 Removal of the machine hoods, Engine hood, Front hood, Right-hand fender

Page 26

MAINTENANCE

Removal of the machine hoods

Engine hood

The engine is accessible for servicing when the engine hood is lifted up.

Tilt the seat forward, release the rubber strap under the seat, and tilt the hood backwards.

Front hood

Release the clip on the front hood and lift off the hood.

Right-hand fender

Remove the knob (1), the screws (2 and 3) and lift off the fender.

Left-hand fender

Release the screws in the fender (2) and lift off the fender.

6008-001

6017-215

3

2

11

6017-003

6017-013

24 – English

Image 26

Contents Rider EnglishSvenska Contents II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenTowing IV. ServiceTravel and transport on public roads Intended useTravel and transport on public roads IntroductionDear customer TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Removal of the machine hoodsEngine hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Adjusting the throttle wire Replacement of the fuel filterService of the air filter Fitting the wrong spark plug type can damage the engine BatteryIgnition system Inspecting the safety system Check the engine’s cooling air intake Main fuseChecking the tyre pressure Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiChanging the oil LubricationCheck the engine’s oil level Dip stick must not be screwed downCheck the transmission’s oil level Lubricating the belt adjusterChange of oil filter General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01