Husqvarna Rider 155 manual 6017-221 6017-222 8009-122 6017-223

Page 39

MAINTENANCE

4.Fit the support wheels on either side of the rear of the cutting unit.

WARNING!

Wear protective glasses when dismantling the cutting unit. The spring which tensions up the belt can go off and cause personal injury.

5.Disengage the spring for the drive belt tensioning wheel.

6.Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut.

7. Engage the strut in the holder.

6017-221

6017-222

8009-122

6017-223

English – 37

Image 39

Contents English RiderSvenska Contents III. Children Safe operation practices for ride-on mowersGeneral operation II. Slope operationIntended use IV. ServiceTravel and transport on public roads TowingTowing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceStarting Instruction Explanation of SymbolsPlacards General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Cold engine DrivingBefore starting Starting the engineWarm engine Driving the machine Cutting tips Release lever Stopping the engineHours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removal of the machine hoodsEngine hood Front hoodChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Adjusting the throttle wireService of the air filter Battery Ignition systemFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit 6017-216 Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belt Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pinDip stick must not be screwed down LubricationCheck the engine’s oil level Changing the oilGeneral lubrication Lubricating the belt adjusterChange of oil filter Check the transmission’s oil levelProblem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data Work done Date, mileage, stamp, sign Service JournalService Journal ´+H-¶5c¨ English 114 01