Husqvarna Rider 155 Restoring from service position, Observe caution to avoid trapping your hand

Page 40

MAINTENANCE

WARNING!

Observe caution to avoid trapping your hand.

8. Lift off the drive belt (1). Then pull out the pin (2).

1

2

6017-225

9. Pull the frame forwards and refit the pin.

6017-226

10.Grasp the front edge of the cutting unit, pull out and raise into the service position.

If the cylindrical bolt, which is now holding the cutting unit is removed, the cutting unit can be lifted off.

Restoring from service position

To leave the service position, reverse the procedures set out in “Placing in the service position”. Make sure that the cutting unit’s ”lug” (3) enters the loop correctly on the underside of the machine, see diagram.

6017-227

8009-438

38 – English

Image 40

Contents Rider EnglishSvenska Contents Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Travel and transport on public roadsTowing Intended useIntroduction Dear customerTravel and transport on public roads TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for cutting unitSeat Lever for adjustment of cutting heightFuelling Driving Before startingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursRemoval of the machine hoods Engine hoodFront hood Right-hand fenderAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Adjusting the throttle wire Replacement of the fuel filterService of the air filter Ignition system BatteryFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Dip stick must not be screwed downLubricating the belt adjuster Change of oil filterCheck the transmission’s oil level General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01