Husqvarna Rider 155 manual Stopping the engine, Release lever

Page 24

DRIVING

WARNING!

Never drive the machine on ground with a slope of more than 15°. Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

Stopping the engine

Preferably allow the engine to idle for a minute (always min 15 sec) to obtain normal working temperature before stopping it, if it has been working hard.

1.Lift up the cutting unit by pulling the lever back to the end position.

2.Pull back the throttle control and turn the ignition key to the STOP position.

3. When the Rider is at a standstill, press down the

parking brake and push in the locking button.

Release lever

The release control must be pulled out in order for the Rider to be moved when the engine is shutoff.

MAX 15

	6017-002
	6007-014H
STOP	START
	6007-015

6007-217H

22 – English

Image 24

Contents Rider EnglishSvenska Contents Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Travel and transport on public roadsTowing Intended useIntroduction Dear customerTravel and transport on public roads TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Before startingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursRemoval of the machine hoods Engine hoodFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Adjusting the throttle wire Replacement of the fuel filterService of the air filter Battery Ignition systemFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Dip stick must not be screwed downLubricating the belt adjuster Change of oil filterCheck the transmission’s oil level General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01