Husqvarna Rider 155 manual Good service, Serial number

Page 7

INTRODUCTION

Good service

Husqvarna products are sold all over the world and only through servicing dealers. This is to ensure that you, the customer, get the best support and service.

When you need spare parts or advice on service issues, warranty terms, etc., contact:

This Operator’s Manual belongs to machine with serial number:

Engine

Transmission

Serial number

The serial number can be found on the printed plate attached to the front, left-hand side under the seat. Stated on the plate, from the top are:

The machines type designation.

The manufacturer’s type number.

The machine’s serial number.

State the type designation and serial number when ordering spare parts.

The engine identfication numbers appear on a decal affixed to the engine shrouding. The text states:

Model no.

Spec no.

Serial no.

Please state these when ordering spare parts. Include letter suffixes, if there are any.

The transmission’s serial number is stated on the barcode decal located on the front of the housing on the left-hand drive axle:

Type designation is stated above the barcode and starts with the letter “K”.

The serial number is stated above the barcode and has the prefix “s/n”.

The manufacturer’s type number is stated under the barcode and has the prefix “p/n”. State the type designation and serial number when ordering spare parts.

English – 5

Image 7
Contents English RiderSvenska Contents III. Children Safe operation practices for ride-on mowersGeneral operation II. Slope operationIntended use IV. ServiceTravel and transport on public roads TowingTowing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceStarting Instruction Explanation of SymbolsPlacards General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Cold engine DrivingBefore starting Starting the engineWarm engine Driving the machine Cutting tips Release lever Stopping the engineHours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removal of the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Adjusting the throttle wireService of the air filter Ignition system BatteryFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit 6017-216 Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belt Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pinDip stick must not be screwed down LubricationCheck the engine’s oil level Changing the oilGeneral lubrication Lubricating the belt adjusterChange of oil filter Check the transmission’s oil levelProblem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data Work done Date, mileage, stamp, sign Service JournalService Journal ´+H-¶5c¨ English 114 01