Husqvarna Rider 155 manual Explanation of Symbols, Starting Instruction

Page 8

EXPLANATION OF SYMBOLS

These symbols are on the machine and in the operator’s manual.

Study them carefully so that you know what they mean.

Read the operator’s manual

R N

Reverse

Neutral

Fast

Slow

Engine off

Battery

Choke

Fuel

Oil level

Cutting height

Backwards

Forwards

Ignition

Hydrostatic free wheel

Use hearing protection

Parking brake

Brake

Warning

	Never use the machine if persons, especially	Never carry passengers on the	Warning!	Never drive across a
			Risk that the
	children, or animals, are in the vicinity.	machine or equipment.
			machine can tip over	slope

Keep hands and feet away from

moving parts.

STARTING INSTRUCTION

•READ OPERATOR´S MANUAL.

•CHECK ENGINE OIL LEVEL.

•ENGAGE PARKING BRAKE AND LIFT CUTTING DECK IN TRANSPORT POSITION.

•IF ENGINE IS COLD USE CHOKE.

•START THE ENGINE.

•RELEASE PARKING BRAKE BEFORE DRIVING.

INSTRUCTIONS DE DEMARRAGE

•LIRE LE GUIDE DE CONDUITE.

•VÉRIFIEZ LE NIVEAU D´HUILE MOTEUR.

•SERREZ LE FREIN DE PARKING ET METTRE LE CARTER DE COUPE EN POSITION HAUT.

•SI LE MOTEUR EST FROID, UTILISEZ LE STARTER.

•ACTIONNEZ LE DÉMARREUR.

•DESSERREZ LE FREIN DE PARKING

Drive very slowly

without the cutting unit.

Speed limiter pedal forwards

Neutral

Speed limiter pedal reverse

Switch off the engine and take off the ignition cable before repairs or maintenance

6 – English

Image 8

Contents Rider EnglishSvenska Contents Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Travel and transport on public roadsTowing Intended useIntroduction Dear customerTravel and transport on public roads TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Driving Before startingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursRemoval of the machine hoods Engine hoodFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Adjusting the throttle wire Replacement of the fuel filterService of the air filter Fitting the wrong spark plug type can damage the engine BatteryIgnition system Inspecting the safety system Check the engine’s cooling air intake Main fuseChecking the tyre pressure Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Dip stick must not be screwed downLubricating the belt adjuster Change of oil filterCheck the transmission’s oil level General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01