Husqvarna Rider 155 manual Cutting unit, Lift lever for cutting unit

Page 18

PRESENTATION

Cutting unit

The Rider 155 is equipped with cutting unit.

Combi - 1030 mm/41"

The combi deck functions as a mulching deck when a BioClip plug is mounted. Otherwise, the deck will function as a rear ejection deck.

Lift lever for cutting unit

The lift lever is used to set the cutting unit in transport or cutting position.

If the lever is pulled back the unit will lift up and the blades will automatically stop rotating (transport position).

If the lock button is pressed and the lever is moved forward the unit will be lowered and the blades will automatically start rotating (cutting position).

The lever can also be used to temporarily regulate the cutting height, e.g. for a small mound in the lawn.

6017-214

6004-011H

Lifting of the cutting unit (transport position)

6004-012H

Lowering of the cutting unit (cutting position)

16 – English

Image 18
Contents Rider EnglishSvenska Contents II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenTowing IV. ServiceTravel and transport on public roads Intended useTravel and transport on public roads IntroductionDear customer TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Starting the engine DrivingBefore starting Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Removal of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Adjusting the throttle wire Replacement of the fuel filterService of the air filter Battery Ignition systemFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiChanging the oil LubricationCheck the engine’s oil level Dip stick must not be screwed downCheck the transmission’s oil level Lubricating the belt adjusterChange of oil filter General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01