Husqvarna Rider 155 manual Warm engine

Page 21

DRIVING

Warm engine:

4.Set the throttle control midway between position 1 and 2.

	1	2
	1	3
		3
		6007-005H

5. Turn the ignition key to start position.

IMPORTANT INFORMATION

Do not run the starter for more than about 10 seconds at a time. If the engine does not start, wait about 60 seconds before trying again.

6.When the engine has started release the ignition key to neutral position.

Push the throttle control to the required speed. For cutting 3/4 to full throttle.

WARNING!

Never run the engine indoors, in enclosed or poorly ventilated areas. The exhaust fumes contain toxic carbon monoxide.

STOP	START
	6007-006

STOP	START
	6007-007

English – 19

Image 21

Contents English RiderSvenska Contents General operation Safe operation practices for ride-on mowersII. Slope operation III. ChildrenTravel and transport on public roads IV. ServiceTowing Intended useDear customer IntroductionTravel and transport on public roads TowingSerial number Good serviceStarting Instruction Explanation of SymbolsPlacards General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Before starting DrivingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Removal of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Adjusting the throttle wireService of the air filter Battery Ignition systemFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit 6017-216 Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belt Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pinCheck the engine’s oil level LubricationChanging the oil Dip stick must not be screwed downChange of oil filter Lubricating the belt adjusterCheck the transmission’s oil level General lubricationProblem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data Work done Date, mileage, stamp, sign Service JournalService Journal ´+H-¶5c¨ English 114 01