Husqvarna Rider 155 manual Driving, Before starting, Starting the engine, Cold engine

Page 20

DRIVING

IMPORTANT INFORMATION

The air intake grille in the engine cover behind the driver’s seat must not be blocked by, for example, clothing, leaves, grass or dirt.

Impaired cooling of the engine. Risk of major engine damage.

Before starting

•Read the safety instructions and information on the location and function of the controls before starting.

•Conduct daily maintenance before starting (see “Maintenance Schedule”).

Starting the engine

1.Lift up the cutting unit by pulling the lever backwards to locked position (transport position).

2.Apply the parking brake. This is done as follows:

•Press down the brake pedal (1).

•Press in the lock button on the steering column (2).

•Release the brake pedal while the button is held pressed.

The parking brake lock disconnects automatically when the brake pedal is pressed down.

Cold engine:

3.Push the throttle control to position 3 (choke position). In this position the engine receives a richer mixture so that the engine starts more easily.

8009-431

		6007-001H
		2
		1
		6017-011
	1	2
	1	3
		3
		6007-004H

18 – English

Image 20

Contents Rider EnglishSvenska Contents Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Travel and transport on public roadsTowing Intended useIntroduction Dear customerTravel and transport on public roads TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Driving Before startingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursRemoval of the machine hoods Engine hoodFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Adjusting the throttle wire Replacement of the fuel filterService of the air filter Fitting the wrong spark plug type can damage the engine BatteryIgnition system Inspecting the safety system Check the engine’s cooling air intake Main fuseChecking the tyre pressure Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Dip stick must not be screwed downLubricating the belt adjuster Change of oil filterCheck the transmission’s oil level General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01