Husqvarna Rider 155 Change of oil filter, Check the transmission’s oil level, General lubrication

Page 44

LUBRICATION

Change of oil filter

Replace oil filter every 200 operating hours. Drain oil first using the plug on the filter base. Remove the old filter using an oil filter tool. Lightly coat rubber gasket with new oil, then install filter by turning it to the right until hand tight. Tighten the filter an additional 1/2 turn. Check that the drain plug is reinstalled before starting the engine.

Start engine and check for leakage.

Check the transmission’s oil level

1.Remove the transmission cover. Loosen both screws (one on each side) and lift off the transmission cover.

2.Check that there is oil in the transmission’s oil tank. Fill if necessary with engine oil

SAE 10W/30 (class SF–CC).

Lubricating the belt adjuster

The belt adjuster should be lubricated regularly using good quality molybdenum disulphide grease*.

1 nipple from the right-hand side under the engine’s lower belt pulley, until grease is forced out.

With daily use lubrication should be conducted twice a week.

General lubrication

All joints and bearings are lubricated on manufacture with molybdenum sulphide grease. Re-grease with same type of grease*. Lubricate the steering and control wires with engine oil.

The machine should be lubricated regularly, and twice a week when used daily.

8009-466

6008-039H

6008-240H

6008-232

*Grease from well-known brand names (petrol companies, etc.) usually maintains a good quality. The most important property is that the grease provides good protection against corrosion.

42 – English

Image 44
Contents Rider EnglishSvenska Contents Safe operation practices for ride-on mowers General operationII. Slope operation III. ChildrenIV. Service Travel and transport on public roadsTowing Intended useIntroduction Dear customerTravel and transport on public roads TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Driving Before startingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval HoursRemoval of the machine hoods Engine hoodFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Adjusting the throttle wire Replacement of the fuel filterService of the air filter Fitting the wrong spark plug type can damage the engine BatteryIgnition system Inspecting the safety system Check the engine’s cooling air intake Main fuseChecking the tyre pressure Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiLubrication Check the engine’s oil levelChanging the oil Dip stick must not be screwed downLubricating the belt adjuster Change of oil filterCheck the transmission’s oil level General lubricationTrouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01