Husqvarna Rider 155 manual Removing the cutting unit

Page 34

MAINTENANCE

6.Move the support wheels to their parking position.

7.Fit the front cover.

WARNING!

Wear protective glasses when installing or removing the cutting unit. The collet spring which tensions up the belt can go off and cause personal injury.

8. Secure the collet spring.

Removing the cutting unit

1.Carry out points 1-9 to put the cutting unit in the service position, see “Service position for the cutting unit”.

2.Remove the bolt (3) and lift off the cutting unit.

8009-439

8009-440

2

1

3

6017-021

32 – English

Image 34

Contents Rider EnglishSvenska Contents II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenTowing IV. ServiceTravel and transport on public roads Intended useTravel and transport on public roads IntroductionDear customer TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for cutting unitSeat Lever for adjustment of cutting heightFuelling Starting the engine DrivingBefore starting Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Removal of the machine hoodsEngine hood Right-hand fenderAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Adjusting the throttle wire Replacement of the fuel filterService of the air filter Ignition system BatteryFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiChanging the oil LubricationCheck the engine’s oil level Dip stick must not be screwed downCheck the transmission’s oil level Lubricating the belt adjusterChange of oil filter General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01