Husqvarna Rider 155 manual Service position for cutting unit, Placing in service position

Page 38

MAINTENANCE

Service position for cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in service position

1.Position the machine on flat ground. Apply the parking brake (A).

Adjust the cutting unit to the lowest cutting height and lower the cutting unit (B).

8009-437

2.Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

3.Remove the two support wheels from under the front hood.

6017-219

6017-220

36 – English

Image 38

Contents Rider EnglishSvenska Contents II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. ChildrenTowing IV. ServiceTravel and transport on public roads Intended useTravel and transport on public roads IntroductionDear customer TowingGood service Serial numberExplanation of Symbols Starting InstructionPlacards Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Cold engineWarm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Removal of the machine hoodsEngine hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Adjusting the throttle wire Replacement of the fuel filterService of the air filter Fitting the wrong spark plug type can damage the engine BatteryIgnition system Inspecting the safety system Check the engine’s cooling air intake Main fuseChecking the tyre pressure Fitting the cutting unit Observe caution to avoid trapping your handRemoving the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belt Service position for cutting unit Placing in service position6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug CombiChanging the oil LubricationCheck the engine’s oil level Dip stick must not be screwed downCheck the transmission’s oil level Lubricating the belt adjusterChange of oil filter General lubricationTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data Service Journal Work done Date, mileage, stamp, signService Journal ´+H-¶5c¨ English 114 01