Husqvarna Rider 155 manual Fitting the cutting unit, Observe caution to avoid trapping your hand

Page 33

MAINTENANCE

Fitting the cutting unit

1.Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.

Make sure the support wheels are fitted to the cutting unit (1).

2.Grasp the handle at the front or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower.

Make sure that the tongue (3) on the cutting unit engages correctly.

3. Insert the bolt and secure it with a locking pin.

WARNING!

Observe caution to avoid trapping your hand.

3

1

2

6017-159

8009-438

6017-120

4.Press down the frame and insert the pin. Fit the drive belt around the drive wheels of the cutting unit.

5. Hook up the height adjustment strut.

6017-160

English – 31

Image 33

Contents English RiderSvenska Contents General operation Safe operation practices for ride-on mowersII. Slope operation III. ChildrenTravel and transport on public roads IV. ServiceTowing Intended useDear customer IntroductionTravel and transport on public roads TowingSerial number Good serviceStarting Instruction Explanation of SymbolsPlacards General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Before starting DrivingStarting the engine Cold engineWarm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Removal of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Adjusting the throttle wireService of the air filter Battery Ignition systemFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit 6017-216 Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belt Placing in service position Service position for cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pinCheck the engine’s oil level LubricationChanging the oil Dip stick must not be screwed downChange of oil filter Lubricating the belt adjusterCheck the transmission’s oil level General lubricationProblem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data Work done Date, mileage, stamp, sign Service JournalService Journal ´+H-¶5c¨ English 114 01