2. PRESENTATION
Working method
Automower automatically mows the lawn. Automower automatically mows the lawn. When the battery is discharged the mower stops on the lawn, and you need to carry it to the loop generator/charger for charging.
When Automower body hits an obstacle, the mower reverses and selects a new direction.
Two sensors, at the front and back on Automower, sense when the mower approaches the boundary wire. Automower overruns the wire by up to
27 centimetres before it turns.
The STOP button on the top of Automower is mainly used to stop the mower when it’s running. When the STOP button is pressed a cover opens, behind which there is a control panel. The STOP button remains depressed until the cover is closed again. This acts as start inhibitor.
You start the mower via the control panel on top of Automower. Open the control panel cover by pressing down the STOP button.
A four digit PIN code must be chosen and entered when the main switch is set in the ON position for the first time. (see page 30).
The chosen PIN code must then be entered each time the mower is started. If the mower does not start within 20 seconds the PIN code must be
Automower can, to save energy, enter sleep mode. The indicator lamps on the control panel are then turned off completely.
The sleep mode is activated 25 minutes after the STOP button has been pressed and then not reset to the operating mode. Automower is then activated by switching the main switch off and on.
The sleep mode can also be activated in the event of a fault occurring during mowing or charging and which is not rectified within 25 minutes. Automower is then activated by pressing the STOP button.
14 - English