Husqvarna 210 C manual Checking the installation, Linking Automower to the loop generator/charger

3. INSTALLATION

3.6 Checking the installation

Check the loop signal by looking to see what indication the green LED on the loop generator/charger is giving.

• Steady light = the signal is okay.

•Flashing once every other second = break in the

loop and no signal found.

•Flashing twice every other second = weak

signal. This may be due to the boundary wire exceeding 250 metres or that the cable is damaged. If the mower works, it is not a problem.

3012-773

3.7Linking Automower™ to the loop generator/charger

1.Connect the loop generator/charger charging cable to the mower's charger contact. At most the mower may be two metres from the working area's boundary wire and the loop generator/charger must be connected to the mains supply.

2.Open the control panel cover by pressing the STOP button. Set the main switch to the ON position.

3.The yellow indicator lamp PIN code should now flash.

4.Select and enter a four digit PIN code. All combinations except 0000 are permitted.

5.Press the YES button.

6.Confirm the selected PIN code by re-entering the PIN code.

7.Press the YES button.

8.The yellow indicator lamp PIN code flashes once, and then remains unlit.

When you have selected a PIN code, the mower and loop generator/charger are linked to each other and the mower can be operated.

2 m

3012-758

3012-797

3012-785

English - 27