Husqvarna 210 C manual Underframe and blade disc, Chassis, Wheels

Page 37

7. MAINTENANCE

Underframe and blade disc

1.Set the main switch to the OFF position.

2.Wear protective gloves.

3012-749

3012-272

3.Lift Automower onto its side.

4.Clean the blade disc and underframe using, e.g. a dish-brush.

At the same time, check that the blade disc rotates freely in relation to the motor support, directly above. Check also that the skid plate rotates freely in relation to the blade disc.

If long blades of grass or other objects work their way in this can brake the blade disc and/or skid plate. Even a slight braking effect leads to a higher consumption of energy and longer mowing times, and at the worst will prevent the mower from being able to mow a large lawn. If more thorough cleaning is necessary the skid plate, and possibly the blade disc, must be dismantled. If necessary, contact your dealer.

3012-393

3012-394

Chassis

Clean the underside of the chassis. Brush or wipe with a damp cloth.

IMPORTANT INFORMATION

Do not use running water when cleaning.

Wheels

Clean around the front and rear wheels and around the front wheel suspension.

38 - English

Image 37

Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique 3012-422 Working method Movement pattern One Automower in several gardensCarry out the installation in the following steps InstallationPreparations Installation of the loop generator/chargerInstallation and connecting the loop generator/charger Charging the batteryBest position for the boundary wire Installation of the boundary wireBoundaries for the working area 30 cm10 cm Boundaries within the working area Slopes Secondary areasLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Linking Automower to the loop generator/charger Checking the installationStarting Automower UseStopping Automower Adjusting the cutting height Switching off AutomowerRestart Changing the PIN code Sound Significance SoundsSelect Control panelNumbers Indicator lamps Main switchGarden example Proposals for installationGarden with steep inclines can be mown Battery MaintenanceCleaning ServiceWinter storage AutomowerUnderframe and blade disc Do not use running water when cleaningChassis WheelsBody Replacing the blades3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Environmental Information Technical dataData Automower 210 C EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03