Husqvarna 210 C manual Installation, Carry out the installation in the following steps

Page 15

3. INSTALLATION

3. Installation

This chapter describes how you install Husqvarna Automower™. Before starting the installation read the previous chapter 2. Presentation.

Read the whole of this chapter too before starting the installation. How the installation is made also affects how well Automower will work. It is therefore important to plan the installation carefully.

Planning is simplified if you make a sketch of the working area, including all obstacles. This makes it easier to see how the boundary wire should ideally be placed. Draw how the boundary wire is to be routed on the sketch.

Carry out the installation in the following steps:

3.1Preparations.

3.2Installation of the loop generator/charger

3.3Charging the battery.

3.4Installation of the boundary wire.

3.5Connecting the boundary wire.

3.6Checking the installation.

3.7Linking Automower™ to the loop generator/charger

In order to carry out a complete start-up of Automower the loop generator/charger and boundary wire must be connected and the mower linked to the loop generator/charger. If you would like to start the mower without having completed the full boundary installation, you can connect a temporary short loop around the mower.

16 - English

Image 15

Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique 3012-422 Working method Movement pattern One Automower in several gardensCarry out the installation in the following steps InstallationPreparations Installation of the loop generator/chargerInstallation and connecting the loop generator/charger Charging the batteryBest position for the boundary wire Installation of the boundary wire30 cm Boundaries for the working area10 cm Boundaries within the working area Slopes Secondary areasLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Linking Automower to the loop generator/charger Checking the installationUse Starting AutomowerStopping Automower Switching off Automower Adjusting the cutting heightRestart Changing the PIN code Sound Significance SoundsControl panel SelectNumbers Indicator lamps Main switchGarden example Proposals for installationGarden with steep inclines can be mown Battery MaintenanceAutomower ServiceCleaning Winter storageWheels Do not use running water when cleaningUnderframe and blade disc ChassisBody Replacing the blades3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Technical data Environmental InformationData Automower 210 C EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03