Husqvarna 210 C manual Winter storage, Service, Cleaning, Automower, Loop generator/charger

Page 36

7. MAINTENANCE

7.2 Winter storage

Automower™

Automower must be carefully cleaned before winter storage, see 7.4 Cleaning on page 39.

Charge the battery fully before winter storage. Turn the main switch to the OFF position. Store the mower horizontally on all four wheels in an area that is dry and free from frost, preferably in the original packaging.

Loop generator/charger

If possible store the loop generator/charger indoors. The boundary wire can be left in the ground. If the loop generator/charger is taken in you should protect the ends of the boundary wire from moisture by placing them, for example, in a tin with grease. If indoor storage is not possible, the boundary wire should remain connected and the loop generator/charger should remain connected to the mains supply.

7.3 Service

Take your Automower to a dealer for a service before winter storage.

During a service the dealer can perform careful cleaning and at the same time test the mower’s functions and components.

7.4 Cleaning

It is important to keep Automower clean. A mower with a large amount of clippings negotiates slopes very poorly.

Never use a high-pressure washer or even running water to clean Automower.

We recommend a brush and spray with water.

3012-751

3012-752

3012-271

English - 37

Image 36
Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Safety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toFunction of Automower CapacityMowing technique 3012-422 Working method One Automower in several gardens Movement patternInstallation Carry out the installation in the following stepsInstallation of the loop generator/charger PreparationsCharging the battery Installation and connecting the loop generator/chargerInstallation of the boundary wire Best position for the boundary wire30 cm Boundaries for the working area10 cm Boundaries within the working area Secondary areas SlopesLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Checking the installation Linking Automower to the loop generator/chargerUse Starting AutomowerStopping Automower Switching off Automower Adjusting the cutting heightRestart Changing the PIN code Sounds Sound SignificanceControl panel SelectNumbers Main switch Indicator lampsProposals for installation Garden exampleGarden with steep inclines can be mown Maintenance BatteryService CleaningWinter storage AutomowerDo not use running water when cleaning Underframe and blade discChassis WheelsReplacing the blades Body3012-260 Trouble shooting Fault messagesTrouble Shooting Fault symptom Technical data Environmental InformationData Automower 210 C EU declaration of conformity EU Declaration of Conformity only applies to EuropeEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03