Husqvarna 210 C manual 3012-260

Page 39

7. MAINTENANCE

5.Unscrew the blade. Use a straight slot or cross-tip screwdriver.

3012-260

6.Pry apart the skid plate and blade disc a little and remove the blade and screw.

7.Screw tight the new blade.

40 - English

Image 39

Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique 3012-422 Working method Movement pattern One Automower in several gardensCarry out the installation in the following steps InstallationPreparations Installation of the loop generator/chargerInstallation and connecting the loop generator/charger Charging the batteryBest position for the boundary wire Installation of the boundary wire30 cm Boundaries for the working area10 cm Boundaries within the working area Slopes Secondary areasLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Linking Automower to the loop generator/charger Checking the installationUse Starting AutomowerStopping Automower Switching off Automower Adjusting the cutting heightRestart Changing the PIN code Sound Significance SoundsControl panel SelectNumbers Indicator lamps Main switchGarden example Proposals for installationGarden with steep inclines can be mown Battery MaintenanceAutomower ServiceCleaning Winter storageWheels Do not use running water when cleaningUnderframe and blade disc ChassisBody Replacing the blades3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Technical data Environmental InformationData Automower 210 C EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03