Husqvarna 210 C Charging the battery, Installation and connecting the loop generator/charger

Page 17

3. INSTALLATION

Tip! If, for reasons of space or for some other reason, it is not suitable to charge the mower where the loop generator/charger is positioned, a freestanding charger can also be used. A charger can be purchased as an accessory. Contact your dealer for further information.

3012-784

Installation and connecting the loop generator/charger

1.Position the loop generator/charger in a suitable spot.

2.Connect the loop generator/charger's power cord to a 230 V wall socket. It is preferable to use an earth-fault breaker as recommended.

3.3 Charging the battery

Automower is supplied with an uncharged battery. As soon as the loop generator/charger is connected, it is possible to charge the mower.

1.Set the main switch to the ON position.

2.Connect the charger cable from the loop generator/charger to the charger contact on the mower. The green indicator lamp Battery should now be lit with a steady light. The indicator lamp goes out when the mower is fully charged.

3.From an uncharged state the battery takes about 12 - 15 hours until it is fully charged.

Tip! Leave the mower connected to the charger cable when not in use. As long as the mower is connected it will be maintenance charged, which means the battery will be fully charged when the mower is used.

3012-758

IMPORTANT INFORMATION

Automower cannot be used before the installation is complete.

18 - English

Image 17

Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Mowing technique Function of AutomowerCapacity 3012-422 Working method Movement pattern One Automower in several gardensCarry out the installation in the following steps InstallationPreparations Installation of the loop generator/chargerInstallation and connecting the loop generator/charger Charging the batteryBest position for the boundary wire Installation of the boundary wire10 cm 30 cmBoundaries for the working area Boundaries within the working area Slopes Secondary areasLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Linking Automower to the loop generator/charger Checking the installationStopping Automower UseStarting Automower Restart Switching off AutomowerAdjusting the cutting height Changing the PIN code Sound Significance SoundsNumbers Control panelSelect Indicator lamps Main switchGarden example Proposals for installationGarden with steep inclines can be mown Battery MaintenanceCleaning ServiceWinter storage AutomowerUnderframe and blade disc Do not use running water when cleaningChassis WheelsBody Replacing the blades3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Data Automower 210 C Technical dataEnvironmental Information EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03