Husqvarna 210 C manual Secondary areas, Slopes

Page 21

3. INSTALLATION

Secondary areas

It is recommended to create a secondary area when the working area is made up of two areas that are joined by a passage where the distance between the boundary wires is less than 60 cm. Run the boundary wire then around the secondary area so that it forms an island outside of the main area.

Automower must be moved manually between the main and secondary areas.

Instead of forming an island with the boundary wire, it can be beneficial to use an extra loop generator/charger together with an extra boundary wire. A loop generator/charger can be purchased as an accessory. Contact your dealer for further information.

Slopes

The boundary wire can be laid across a slope that slants less than 10 %.

The boundary wire should not be laid across a slope that is steeper than 10 %. There is a risk of Automower finding it difficult to turn, and being unable to move. The risk is at its greatest in damp weather conditions, as the wheels can slip on the wet grass.

However, the boundary wire can be laid across a slope steeper than 10 % when there is an obstacle that Automower can be permitted to collide with, for example, a fence or a dense hedge.

Secondary

area

Main area

3012-682

3012-767

3012-768

22 - English

Image 21
Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique 3012-422 Working method Movement pattern One Automower in several gardensCarry out the installation in the following steps InstallationPreparations Installation of the loop generator/chargerInstallation and connecting the loop generator/charger Charging the batteryBest position for the boundary wire Installation of the boundary wire30 cm Boundaries for the working area10 cm Boundaries within the working area Slopes Secondary areasLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Linking Automower to the loop generator/charger Checking the installationUse Starting AutomowerStopping Automower Switching off Automower Adjusting the cutting heightRestart Changing the PIN code Sound Significance SoundsControl panel SelectNumbers Indicator lamps Main switchGarden example Proposals for installationGarden with steep inclines can be mown Battery MaintenanceCleaning ServiceWinter storage AutomowerUnderframe and blade disc Do not use running water when cleaningChassis WheelsBody Replacing the blades3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Technical data Environmental InformationData Automower 210 C EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03