Husqvarna 210 C manual Laying out the boundary wire

Page 22

3. INSTALLATION

Automower can mow areas inside the working area that slope up to 35 cm per distance metre (35 %). Areas that slope more must be demarcated by the boundary wire.

When any part of the working area's boundary slopes more than 10 cm per distance metre (10 %), the boundary wire must be routed about 35 cm in on flat ground before the slope starts.

3012-769

Laying out the boundary wire

Run the boundary wire around the working area, but wait before connecting the wire to the loop generator/charger.

IMPORTANT INFORMATION

Extra wire must not be placed in coils outside the boundary wire. This can disrupt Automower™.

Tip! Use the supplied measurement gauge as a guide when you lay out the boundary wire. This helps you to easily set the correct distance between the boundary wire and the boundary/obstacle.

If you intend to staple down the boundary wire:

Tip! Mow the lawn where the wire is to be laid using a normal lawn mower or a trimmer. It will then be easier to lay the wire close to the ground and the risk of the mower cutting the wire off is reduced.

3012-221

3012-281

English - 23

Image 22
Contents Husqvarna Automower 210 C OPERATOR’S Manual Table of Contents Table of Contents Introduction Safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Safety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toCapacity Function of AutomowerMowing technique 3012-422 Working method One Automower in several gardens Movement patternInstallation Carry out the installation in the following stepsInstallation of the loop generator/charger PreparationsCharging the battery Installation and connecting the loop generator/chargerInstallation of the boundary wire Best position for the boundary wireBoundaries for the working area 30 cm10 cm Boundaries within the working area Secondary areas SlopesLaying out the boundary wire 3012-745 3012-535 Connecting the boundary wire Checking the installation Linking Automower to the loop generator/chargerStarting Automower UseStopping Automower Adjusting the cutting height Switching off AutomowerRestart Changing the PIN code Sounds Sound SignificanceSelect Control panelNumbers Main switch Indicator lampsProposals for installation Garden exampleGarden with steep inclines can be mown Maintenance BatteryWinter storage ServiceCleaning AutomowerChassis Do not use running water when cleaningUnderframe and blade disc WheelsReplacing the blades Body3012-260 Trouble shooting Fault messagesTrouble Shooting Fault symptom Environmental Information Technical dataData Automower 210 C EU declaration of conformity EU Declaration of Conformity only applies to EuropeEU Declaration of Conformity Index Trouble Shooting Guide symptom 115 03