3Com Switch 8800 Configuration Guide Chapter 13 DHCP Configuration
13-19
Operation Command
Display the information about IP address
binding in DHCP address pool(s)
display dhcp server ip-in-use { ip
ip-address | pool [ pool-name ] |
interface [ vlan-interface vlan_id ] | all }
Display the statistics about the DHCP
server display dhcp server statistics
Display the information about the
tree-like structure of DHCP address
pool(s)
display dhcp server tree { pool
[ pool-name ] | interface
[ vlan-interface vlan_id ] | all }
Perform the following configuration in user view.
Table 13-31 Enable/Disable debugging for the DHCP server
Operation Command
Disable debugging for the DHCP server undo debugging dhcp server { all |
error | event | packet }
Enable debugging for the DHCP server debugging dhcp server { all | error |
event | packet }
You can clear the configuration information of the DHCP server by executing the reset
command in user view.
Perform the following configuration in user view.
Table 13-32 Clear the configuration information of the DHCP server
Operation Command
Clear the statistics about DHCP address
conflicts reset dhcp server conflict { ip
ip-address | all }
Clear the information about dynamically
bound DHCP addresses
reset dhcp server ip-in-use{ all |
interface [ vlan-interface vlan_id ] | ip
ip-address | pool [ pool-name ] }
Clear the statistics about the DHCP
server reset dhcp server statistics
I. Network requirements
As shown in Figure 13-2, two DHCP clients at the same network segment (10.110.0.0)
are connected to the following switch through a port in VLAN2. The switch, acting as a