3Com Switch 8800 Configuration Guide Chapter 31 MBGP Multicast Extension Configuration
31-7
By default, there is no route reflector in an AS.
It is generally unnecessary to configure this command for a peer group. This command
is reserved for the occasional compatibility with the network equipments of other
vendors.
VI. Configuring the local address as the next hop when advertising routes
This involves removing the next hop configuration in the routing information advertised
to a peer (group) and configuring the local address as the next hop address. It is valid
only for IBGP peers/peer groups.
Please perform the following configurations in IPV4 multicast sub-address family view.
Table 31-7 Configuring the local address as the next hop when advertising routes
Operation Command
Configure the local address as the next
hop when advertising routing
information peer group-name next-hop-local
Remove the above configuration undo peer group-name next-hop-local
VII. Specifying the routing policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.
Table 31-8 Specifying the routing policy for a peer (group)
Operation Command
Configure routing policy for
incoming packets peer { group-name | peer-address } route-policy
policy-name import
Remove incoming policy
cnfiguration undo peer { group-name | peer-address }
route-policy policy-name import
Configure routing policy for
outgoing packets peer group-name route-policy policy-name
export
Remove outgoing policy
cnfiguration undo peer group-name route-policy
policy-name export
By default, no routing policy is specified for any peer (group).
VIII. Configuring IP-ACL-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.