3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-19
Enable terminal display function of trap information terminal trapping
Disable terminal display function of trap information undo terminal trapping
To send configuration information to Telnet terminal or dumb terminal, follow the steps
below:
1) Enabling info-center
Perform the following configuration in system view.
Table 46-29 Enable/disable Info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to Telnet terminal or dumb terminal
Perform the following configuration in system view.
Table 46-30 Configure to output information to Telnet terminal or dumb terminal
Operation Command
Output information to Telnet terminal or
dumb terminal info-center monitor channel
{ channel-number | channel-name }
Cancel the configuration of outputting
information to Telnet terminal or dumb
terminal undo info-center monitor channel
3) Configuring information source on the switch
By this configuration, you can define the information that sent to Telnet terminal or
dumb terminal is generated by which modules, information type, information level, and
so on.
Perform the following configuration in system view: