3Com Switch 8800 Configuration Guide Chapter 19 OSPF Configuration
19-22
By default, all interfaces are allowed to transmit and receive OSPF packets.
After an OSPF interface is set to be in silent status, the interface can still advertise its
direct route. However, the OSPF hello packets of the interface will be blocked, and no
neighboring relationship can be established on the interface. Thereby, the capability for
OSPF to adapt to the networking can be enhanced, which will hence reduce the
consumption of system resources. On a switch, this command can disable/enable the
specified VLAN interface to send OSPF packets.
19.2.19 Configuring OSPF Authentication

I. Configuring the OSPF Area to Support Packet Authentication

All the routers in one area must use the same authentication mode (no authentication,
simple text authentication or MD5 cipher text authentication). If the mode of supporting
authentication is configured, all routers on the same segment must use the same
authentication key. To configure a simple text authentication key, use the
authentication-mode simple command. Use the authentication-mode md5
command to configure the MD5 cipher text authentication key if the area is configured
to support MD5 cipher text authentication mode.
Perform the following configuration in OSPF area view.
Table 19-25 Configure the OSPF area to support packet authentication
Operation Command
Configure the area to support authentication
type
authentication-mode { simple |
md5 }
Cancel the configured authentication mode undo authentication-mode
By default, the area does not support packet authentication.

II. Configuring OSPF packet authentication

OSPF supports simple authentication or MD5 authentication between neighboring
routers.
Perform the following configuration in interface view.
Table 19-26 Configure OSPF packet authentication
Operation Command
Specify a password for OSPF simple text
authentication on the interface
ospf authentication-mode simple
password
Cancel simple authentication on the
interface
undo ospf authentication-mode
simple
Specify the interface to use MD5
authentication
ospf authentication-mode md5
key_id key