3Com Switch 8800 Configuration Guide Chapter 33 QoS Configuration
33-22
Configure traffic statistics which only
applies link group ACL
traffic-statistic inbound link-group
{ acl-number | acl-name } [ rule rule
[ system-index index ] ] [ tc-index
index ]
Remove traffic statistics setting which
only applies link group ACL
undo traffic-statistic inbound
link-group { acl-number | acl-name }
[ rule rule ]
Display traffic statistics for the port display qos-interface [ interface-name
| interface-type interface-num ]
traffic-statistic
Note:
The system counts the traffic on all ports in the group after you use the traffic-statistic
command in port group view.
system-index index here is the system index for an ACL rule. When delivering a rule,
the system assigns an index to it, for convenience of later retrieval. You can also assign
a system index for it when delivering an ACL rule with this command. However, you are
not recommended to assign a system index if not urgently necessary.
See the corresponding Command Manual for details of the commands.
33.3.11 Displaying and Debugging QoS Configuration
After these configurations are completed, you can use the display command in any
view to view QoS running and check configuration result. You can clear QoS statistics
using the reset traffic-statistic command in Ethernet port view or port group view.
Table 33-16 Display and debug QoS configurations
Operation Command
Display traffic mirroring
configuration of a port display qos-interface [ interface-name |
interface-type interface-num ] mirrored-to
Display traffic priority
configuration of a port
display qos-interface [ interface-name |
interface-type interface-num ] traffic-priority
Display traffic redirection
configuration of a port
display qos-interface [ interface-name |
interface-type interface-num ] traffic-redirect
Display traffic statistics of a
port
display qos-interface [ interface-name |
interface-type interface-num ] traffic-statistic
Display port mirroring
configuration display mirroring-group [ groupid ]
Display QoS configurations of
all ports display qos-interface [ interface-name |
interface-type interface-num ] all