3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-23
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channelnum chunnel except default;
level refers to the severity levels; severity specifies the severity level of information.
The information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to log buffer, channel-number or channel-name
must be set to the channel that corresponds to logbuffer direction.
Every channel has been set with a default record, whose module name is default and
the module numbe r is 0x ffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following configuration in system view:
Table 46-37 Configure the output format of time-stamp
Operation Command
Configure the output format of the
time-stamp info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled undo info-center timestamp { log |
trap | debugging }
To send configuration information to the trap buffer, follow the steps below:
1) Enabling info-center
Perform the following configuration in system view.
Table 46-38 Enable/disable info-center
Operation Command
Enable info-center info-center enable