3Com Switch 8800 Configuration Guide Chapter 20 Integrated IS-IS Configuration
20-8
Configuring IS-IS Route Metric Type
z Setting IS-IS Link State Routing Cost
z Configuring IS-IS Timers
z Setting to Discard the LSPs with Checksum Errors
z Setting LSP Refreshment Interval
z Setting Lifetime of LSP
z Setting Parameters Related to SPF
4) Configuration related to IS-IS networking
z Setting IS-IS Authentication
z Setting Overload Flag Bit
z Setting to Log the Peer Changes
z Setting the Mesh Group of the Interface
z Enabling/Disabling the Interface to Send Packets
5) Some operation commands
z Resetting All the IS-IS Data Structure
z Resetting the Specified IS-IS Peer
20.2.1 Enabling IS-IS and Entering the IS-IS View After creating an IS-IS routing process, you should also activate this routing process at
an interface that may correlate with another router. After that, the IS-IS protocol can be
started and run.
Perform the following configuration in system view.
Table 20-1 Enable IS-IS and enter the IS-IS view
Operation Command
Enable the IS-IS and enter the IS-IS view isis [ tag ]
The tag argument identifies the IS-IS process. In the present version, just one IS-IS
process is allowed.
By default, the IS-IS routing process is disabled.
20.2.2 Setting Network Entity Title Network Entity Titles (hereafter referred to as NETs) defines the current IS-IS area
address and the system ID of the router.
Perform the following configurations in IS-IS view.
Table 20-2 Set NET
Operation Command
Set a NET network-entity network-entity-title