3Com Switch 8800 Configuration Guide Chapter 18 RIP Configuration
18-6
Perform the following configuration in RIP view.
Table 18-6 Configure RIP to import routes of other protocols
Operation Command
Configure RIP to import routes of other
protocols
import-route protocol [ cost value |
route-policy route-policy-name ]*
Cancel the imported routing information
of other protocols undo import-route protocol
Set the default routing metric default cost value
Restore the default routing metric undo default cost
By default, RIP does not import the route information of other protocols.
If you do not specify the routing metric when importing a route, the default routing
metric 1 is used.
18.2.7 Configuring Route Filtering The router provides the route filtering function. You can configure the filter policy rules
through specifying the ACL and ip-prefix for route import and advertisement. Besides,
to import a route, the RIP packet of a specific router can also be received by
designating a neighbor router.
Perform the following configuration in RIP view.
I. Configuring RIP to filter the received routes
Table 18-7 Configure RIP to filter the received routes
Operation Command
Configure RIP to filter the received routing
information advertised by the specified address filter-policy gateway
ip-prefix-name import
Cancel filtering the received routing information
advertised by the specified address
undo filter-policy gateway
ip-prefix-name import
Configure RIP to filter the received global
routing information
filter-policy { acl-number |
ip-prefix ip-prefix-name } import
Cancel filtering the received global routing
information
undo filter-policy { acl-number |
ip-prefix ip-prefix-name } import