3Com Switch 8800 Configuration Guide Chapter 4 User Interface Configuration
4-8
Note:
By default, password is required to be set for authenticating local users and remote
Modem users log in via the AUX port, and Telnet users log in through Ethernet port. If
no password has been set, the following prompt will be displayed “Login password has
not been set !.”
If the authentication-mode none command is used, the local and Modem users via
the AUX port and Telnet users will not be required to input password.
II. Setting the command level used after a user logging in
The following command is used for setting the command level used after a user logging
in.
Perform the following configuration in local-user view.
Table 4-15 Set the command level used after a user logging in
Operation Command
Set command level used after a user
logging in service-type telnet [ level level ]
Restore the default command level used
after a user logging in undo service-type telnet [ level ]
By default, the specified logon user can access the commands at Level 0.
III. Setting the command level used after a user logs in from a user interface
You can use the following command to set the command level after a user logs in from
a specific user interface, so that a user is able to execute the commands at such
command level.
Perform the following configuration in user interface view.
Table 4-16 Set the command level used after a user logging in from a user interface
Operation Command
Set command level used after a user
logging in from a user interface user privilege level level
Restore the default command level used
after a user logging in from a user
interface undo user privilege level
By default, you can access the commands at Level 3 after logging in through the
Console user interface, and the commands at Level 0 after logging in through the AUX
or VTY user interface.