3Com Switch 8800 Configuration Guide Chapter 38 MSTP Region-configuration
38-22
II. Configuration in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 38-12 Configure the max transmission speed on a port
Operation Command
Configure the max transmission speed on a port stp transmit-limit packetnum
Restore the default max transmission speed on a
port undo stp transmit-limit
You can configure the max transmission speed on a port with either of the
earlier-mentioned measures. For more about the commands, refer to the Command
Manual.
This parameter only takes a relative value without units. If it is set too large, too many
packets will be transmitted during every Hello Time and too many network resources
will be occupied. The default value is recommended.
By default, the max transmission speed on every Ethernet port of the switch is 3.
38.2.10 Configuring a Port as an Edge Port or Non-edge Port An edge port refers to the port not directly connected to any switch or indirectly
connected to a switch over the connected network.
You can configure a port as an edge port or non-edge port in the following ways.
I. Configuration in system view
Perform the following configuration in system view.
Table 38-13 Configure a port as an edge port or a non-edge port
Operation Command
Configure a port as an edge port. stp interface interface-list edged-port
enable
Configure a port as a non-edge port. stp interface interface-list edged-port
disable
Restore the default setting of the port as
a non-edge port.
undo stp interface interface-list
edged-port
II. Configuration in Ethernet port view
Perform the following configuration in Ethernet port view.