44CHAPTER 4: INSTALLING OR REMOVING AN INTERFACE MODULE

3If you are not installing another module, change the jumper to the left-hand set of pins and reinstall the screw on the standoff.

Front panel

Move the jumper to the

left-hand set of pins

4Reinstall the cover and the cover screws.

CAUTION: The DIP switches should all be in the down position. The DIP switches are accessible through an opening on the side of the chassis.

Install screws

DIP switches should all be in the down position

5If the bridge/router was mounted with brackets, reinstall the brackets and remount it.

6Reconnect the power cord and all cables.

Page 44
Image 44
3Com SuperStack II, NETBuilder SI manual Reinstall the cover and the cover screws