3Com SuperStack II, NETBuilder SI manual Phone number is case-sensitive and must be matched exactly

114CHAPTER 9: CUSTOMIZING YOUR SOFTWARE

ADD !V1 -PORT DialNoList “123-4567a”

ADD !V1 -PORT DialNoList “123-4567b”

The bridge/router dials 123-4567 three times.

Positioning a Phone To insert a phone number into a specific position in the dial number Number list, enter the Pos (Position) keyword with a non-zero number after the

dial string.

For example, to insert a phone number for port 4 into position 2 of the dial number list that contains 10 phone numbers, enter:

ADD !4 -PORT DialNoList “510-555-7000” Pos = 2

The software inserts the new phone number into position 2. The phone number that was previously in position 2 is now in position 3. If the phone already exists in the dial number list, it will be moved to position

2.You can insert the same phone number twice by using blanks or other redundant characters. You also can include the Baud and Type keywords in any order when inserting phone numbers into the dial number list.

Editing an Existing To edit an existing phone number in the dial number list, you can Phone Number change the position in the list, change the baud rate, and change the

device type.

For example, if port 3 has already been assigned 612-345-3989 in position 2 with a baud rate of 64 kbps, you can change the baud rate by entering:

ADD !3 -PORT DialNoList “612-345-3989” Pos = 2 Baud = 14.4

Deleting a Phone Number

Because the dial string is case-sensitive, make sure to match it exactly to successfully edit an existing string when characters other than numbers are used.

To remove a phone number from the dial number list, use:

DELete !<port> -PORT DialNoList “<phone no>”

The phone number is case-sensitive and must be matched exactly.