GLOBAL ADMINISTRATOR SECTION CHAPTER 1: SYSTEM SCREEN

Specify the Block Page Device

In the Block Page Device frame, “LAN2” displays as the default device for sending block pages to client PCs.

TIP: The block page device should be a different device than the one selected in the Listening Device frame.

If necessary, at the Device to send block page pull-down menu, choose the network card that will be used to send the block page to client PCs.

NOTES: After making all selections in this window, click Apply.

The LAN IP address saved for the Device to send block page will display in the IP field at the bottom of the Administrator console.

Specify the Block Page Delivery

In the Block Page Delivery Method frame, specify the block page delivery method by making the following selection(s):

Choose from either of the two Protocol Methods:

“Send Block Page via ARP Table” - this option uses the Address Resolution Protocol method to find the best possible destination MAC address of a specified host, usually the ProxyBlocker gateway.

“Send Block to Specified Host MAC Address” - using this preferred method, the block page will always be sent to the MAC address of a specified host, usually the Proxy- Blocker gateway.

Using this option, choose from either of the two Block Page Route To selections:

“Default Gateway” - this option indicates that the default gateway on your network will be used for sending block pages. If the invisible mode is selected, “Default Gateway” displays by default as the Block Page Route To selection.

132

8E6 TECHNOLOGIES, PROXYBLOCKER USER GUIDE

Page 146
Image 146
8e6 Technologies ProxyBlocker manual Specify the Block Page Device, Specify the Block Page Delivery