English
Chapter 2. Installation
Please follow the steps below to set up your ScanWit film scanner:
Step 1. Install the SCSI interface card
Power off your computer and disconnect the computer power from the power outlet. Open the computer cover and locate the PCI slot of your computer. Select an empty PCI slot and remove its bracket. Insert the SCSI interface card into the PCI slot and secure it by tightening the screw. Close the computer cover.
Step 2. Connect the scanner to your computer
Connect one end of the SCSI cable to the SCSI interface card, and the other end to the "SCSI IN" connector on the rear panel of the scanner. Select the appropriate SCSI ID by pressing the buttons on the SCSI ID selector. Attach the power cord to the scanner and plug in the power outlet.
ID
SCSI OUT
To power outlet
To computer
Rear panel connection
7
