49
Configuring the non-Hot Plug HDD cable cage
This section includes instructions for removing and installing the HDD cable cage as well as procedures on how to install a hard disk into the cage.
Note: The HDD cable cage feature is only applicable to the Altos G510 Basic model.
To remove the HDD cable cage
1Turn off the system and all the peripherals connected to it.
2Unplug all cables from the power outlets.
3Place the system on a flat, stable surface.
4Remove the front bezel, inner front panel, side panel, and air baffle.
5Disconnect the SCSI cable and the SCSI HDD power cable from the hard disk drive.
6Loosen the four thumbscrews that secure the cage to the chassis
(1).
7 Slightly pull out the cage from the chassis (2).
