
Power Management
The Power Management menu lets you configure the system
IMPORTANT:If an
The following screen shows the Power Management parameters and their default settings:
Power Management
Power Management Mode | [Enabled ] |
IDE Hard Disk Standby Timer | [OFF] |
System Sleep Timer | [30] Minute(s) |
Sleep Mode | [Suspend] |
Power Switch < 4 sec | [Power Off] |
System |
|
Modem Ring Indicator | [Enabled ] |
PCI Power Management | [Enabled ] |
Restart on AC/Power Failure | [Enabled ] |
The following table describes the parameters found in this menu. Settings in boldface are the default and suggested settings.
Parameter | Description | Options |
|
|
|
Power Management Mode | Allows you to reduce the system’s power | Enabled or Disabled |
| consumption. When enabled, the IDE hard |
|
| disk and system timers become |
|
| configurable. |
|
|
|
|
IDE Hard Disk Standby Timer | Allows the hard disk to enter Standby mode | 1 to 15 minutes, or Off |
| after inactivity of 1 to 15 minutes, depending |
|
| on your setting. |
|
|
|
|
System Sleep Timer | Automatically puts the system to power- | 2, 5, 10, 15, 20, 30, 40, |
| saving mode after a specified period of | 50...120 minutes, or Off |
| inactivity. Any keyboard or mouse action, or |
|
| any activity detected from the IRQ channels |
|
| resumes system operation. |
|
|
|
|
Sleep Mode | Lets you specify the | Standby or Suspend |
| that the system will enter after a specified |
|
| period of inactivity. This parameter is |
|
| configurable only if the System Sleep Timer |
|
| is enabled. |
|
|
|
|
Power Switch < 4 sec. | Lets you specify whether to automatically | Power Off or Suspend |
| turn off the machine or put the system to |
|
| Suspend mode when the power switch is |
|
| pressed for less than 4 seconds. |
|
|
|
|
System | Lets you specify the activity that will resume |
|
| the system to normal operation. |
|
|
|
|
36 | Chapter 2 |