Actiontec electronic 56K V.90 specs

Step 10 The wizard will find the correct driver on the CD-ROM and announce it is ready to install. Click Next.

Step 11 After Windows has finished copying the drivers to where they belong in your system, it will announce the end of the installation process. Click the Finish button.

17

Image 18

Actiontec electronic 56K V.90 manual

Contents

56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This First For Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware Installation Installing The Modem Connecting Devices to the Modem Connecting Devices Configuring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98 More Info Panel Does Not Install Windows NT Common Problems No Dialtone Error Can’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95 Ltcom.vxd ltwave.inf Page Answer Command AT CommandsRepeat Last Command ATXn Carrier Control Echo Command DnDial Online Data Character Echo Command Hook Control Monitor Speaker Volume Request ID Information This command turns the speaker on or off Modulation Handshake Return On-line to Data Mode Select Pulse DialingResult Code Control DCE Response Format Result Code Option Extended Result Codes Dial Tone Detect Busy Tone Detect Long Space DisconnectRecall Stored Profile Auto Retrain Data Carrier Detect DCD Control Load Factory Settings DTR Control22bis Guard Tone Control Asynchronous Communications Mode Auxiliary Relay optionLocal Flow Control Selection This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR Option LSD Zn=x Store Telephone Number \An \BnModem Port Flow Control \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code \Xn XON/XOFF Pass Through Data Calling Tone V90=x Downstream Rate and Control Write to/Read from DSP Register Enable/Disable Data CompressionAT Commands for Testing and Debugging Line-to-Line Loopback ATI11 XXX Registers Reference Type Ascii S10 Connection Completion Time-OutComma Dial Modifier Time S11 Dtmf Dialing Speed S14 General Bit Mapped Options Status S21S22 S30 Inactivity Timer S24 Timer to Control Sleep ModeS28 Modulation Enable/Disable S32 S37 Dial Line Rate default S35 Data Calling ToneS36 S38 56K Dial Line Rate default S42 Auto Rate default 1, rangeS43 Auto Mode default 1, range S89 Timer to Control Sleep Mode S90S91 S92 No Carrier Result Code FCC Regulations FCC Part 68 RequirementsDeclaration of Conformity Canadian Department Of Communications Cdoc