69
S7 Connection Completion Time-Out
Range: 1-255
Default: 50
Units: seconds
This register sets the time, in seconds, that the modem must wait before hanging up
because carrier is not detected. The timer is started when the modem finishes dialing
(originate), or goes off-hook (answer). In originate mode, the timer is reset upon
detection of an answer tone if allowed by country restriction. The timer also specifies
the wait for silence time for the @ dial modifier in seconds. S7 is not associated with
the W dial modifier.
S8 Comma Dial Modifier Time
Range: 0-65
Default: 2
Units: seconds
This register sets the time, in seconds, that the modem must pause when it encoun-
ters a comma (“,”) in the dial command string.
S10 Automatic Disconnect Delay
Range: 1-254
Default: 20
Units: 0.1 seconds
This register sets the length of time, in tenths of a second, that the modem waits
before hanging up after a loss of carrier. This allows for a temporary carrier loss
without causing the local modem to disconnect. The actual interval the modem waits
before disconnecting is the value in register S10.
S11 DTMF Dialing Speed
Range: 50-150
Default: 95
Units: 0.001 seconds
This register determines the dialing speed which is prefixed for each country.
S12 Escape Guard Time
Range: 0-255
Default: 50
Units: 0.02 seconds
This register sets the value (in 20 ms increments) for the required pause after the
escape sequence (default 1s).