Configuring Windows | Actiontec electronic 56K V.90 manual

Configuring Windows 95

Step 1 Upon startup Windows 95 detects the modem and displays the New Hard- ware Found dialog box. Click “Driver from disk provided by hardware manu- facturer” to select it, then click OK.

Step 2 If Windows asks for an installation disk, insert the modem’s installation CD-ROM, and wait ten seconds so that windows can recognize the CD has been inserted. Type the drive letter of your CD-ROM drive in the dialog box that appears, and click OK.

9

Image 10

Actiontec electronic 56K V.90 manual Configuring Windows

Contents

56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This First For Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware Installation Installing The Modem Connecting Devices to the Modem Connecting Devices Configuring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98 More Info Panel Does Not Install Windows NT Common Problems No Dialtone Error Can’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95 Ltcom.vxd ltwave.inf Page Answer Command AT CommandsRepeat Last Command ATXn Carrier Control Echo Command DnDial Online Data Character Echo Command Hook Control Monitor Speaker Volume Request ID Information This command turns the speaker on or off Modulation Handshake Select Pulse Dialing Return On-line to Data ModeResult Code Control DCE Response Format Result Code Option Extended Result Codes Dial Tone Detect Long Space Disconnect Busy Tone DetectRecall Stored Profile Auto Retrain Data Carrier Detect DCD Control DTR Control Load Factory Settings22bis Guard Tone Control Auxiliary Relay option Asynchronous Communications ModeLocal Flow Control Selection This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR Option LSD Zn=x Store Telephone Number \Bn \AnModem Port Flow Control \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code \Xn XON/XOFF Pass Through Data Calling Tone V90=x Downstream Rate and Control Write to/Read from DSP Register Enable/Disable Data CompressionAT Commands for Testing and Debugging Line-to-Line Loopback ATI11 XXX Registers Reference Type Ascii S10 Connection Completion Time-OutComma Dial Modifier Time S11 Dtmf Dialing Speed S21 S14 General Bit Mapped Options StatusS22 S30 Inactivity Timer S24 Timer to Control Sleep ModeS28 Modulation Enable/Disable S32 S35 Data Calling Tone S37 Dial Line Rate defaultS36 S42 Auto Rate default 1, range S38 56K Dial Line Rate defaultS43 Auto Mode default 1, range S90 S89 Timer to Control Sleep ModeS91 S92 No Carrier Result Code FCC Part 68 Requirements FCC RegulationsDeclaration of Conformity Canadian Department Of Communications Cdoc